PIC16F886-I/SP Datasheet, CAD Models, Applications

Description

The PIC 16F882/883/884/886/887 devices are covered by this data sheet. The PIC1 6F882/883/886 devices are available in 28-pin PDIP, SOIC，SSOP and QFN packages. The PIC1 6F884/887 are available in a 40-pin PDIP and 44-pin QFN and TQFP packages.

 

CAD Models

 

Figure: PCB Symbol

 

 

Figure: Footprint

 

 

Figure: 3D Model

 

Pin Diagrams

 

Figure: Pin Diagrams

 

Block Diagram

 

Figure: Block Diagram

 

Features

Special Microcontroller Features

• Precision Internal Oscillator:

- Factory calibrated to +1%

- Software selectable frequency range of 8MHzto31kHz

- Software tunable

- Two Speed Start-up mode

- Crystal fail detect for critical applications

- Clock mode switching during operation for power savings

• Power-Saving Sleep mode
• Wide Operating Voltage Range (2.0V-5.5V)
• Industrial and Extended Temperature Range
• Power-on Reset (POR)
• Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)

• Brown-out Reset (BOR) with Software Control Option

• Enhanced Low-Current Watchdog Timer (WDT) with On-Chip Oscillator (software selectable nominal 268 seconds with full prescaler) with software enable

• Multiplexed Master Clear with Pull-up/Input Pin
• Programmable Code Protection
• High Endurance Flash/EEPROM Cell:

- 100,000 write Flash endurance

- 1,000,000 write EEPROM endurance

- Flash/Data EEPROM retention: > 40 years

• Program Memory ReadWrite during run time
• In-Circuit Debugger (on board)

 

Low-Power Features

• Standby Current:

- 50 nA @ 2.0V, typical

• Operating Current:

- 11 μA @ 32 kHz, 2.0V, typical

- 220 μA @ 4 MHz, 2.0V, typical

• Watchdog Timer Current:

- 1 μA @ 2.0V, typical

 

Datasheet

You can download the datasheet the link given below.

PIC16F886-I/SP-Datasheet

 

Specifications

TYPE	DESCRIPTION
Category	Integrated Circuits (ICs)
	Embedded - Microcontrollers
Mfr	Microchip Technology
Package	Tube
Product Status	Active
Core Processor	PIC
Core Size	8-Bit
Speed	20MHz
Connectivity	I2C, SPI, UART/USART
Peripherals	Brown-out Detect/Reset, POR, PWM, WDT
Number of I/O	24
Program Memory Size	14KB (8K x 14)
Program Memory Type	FLASH
EEPROM Size	256 x 8
RAM Size	368 x 8
Voltage - Supply (Vcc/Vdd)	2V ~ 5.5V
Data Converters	A/D 11x10b
Oscillator Type	Internal
Operating Temperature	-40℃ ~ 85℃ (TA)
Mounting Type	Through Hole
Package / Case	28-DIP (0.300", 7.62mm)
Supplier Device Package	28-SPDIP
Base Product Number	PIC16F886

 

Manufacturer

Microchip Technology Inc. is a publicly-listed American corporation that manufactures microcontroller, mixed-signal, analog and Flash-IP integrated circuits. Its products include microcontrollers (PIC, dsPIC, AVR and SAM), Serial EEPROM devices, Serial SRAM devices, embedded security devices, radio frequency (RF) devices, thermal, power and battery management analog devices, as well as linear, interface and wireless products.

 

Using Warning

Note: Please check their parameters and pin configuration before replacing them in your circuit.

 

FAQ

What is a CMOS microcontroller?

CMOS technology is used for constructing integrated circuit (IC) chips, including microprocessors, microcontrollers, memory chips (including CMOS BIOS), and other digital logic circuits.

 

What are 8-bit microcontrollers used for?

8-bit MCUs can implement an ultra-low-power platform that includes the complete signal chain for applications such as personal blood pressure monitors, pulsoximeters, and heart rate monitors. Remote patient monitoring is also a growing trend, using devices with integrated RF/ZigBee or Wi-Fi interfaces and transceivers.

 

What is difference between 8bit and 16bit microcontroller?

An 8-bit microcontroller is capable of handling 8-bit data and program memory. A 16-bit microcontroller is capable of handling 16-bit data and program memory. An 8-bit reading bus is present on 8-bit microcontrollers. A 16-bit reading bus is present on 16-bit microcontrollers.